All Power Custom Ruger base pins are hardened, centerless ground to .2495" Diameter, and handsomely finished. Locking pins have an Allen set screw in the head to hold the pin in place against recoil. Installation instructions are included, and on most guns these pins drop right in.
Ruger New Blackhawk, Vaquero, Super Blackhawk, Bisley (large frames) 2.875".
Q-1-03 Knurled Blue.
Q-1-04 Knurled Stainless Steel.
Ruger New Vaquero, Bisley, XR3, (small frame) 2.750".
Q-2-02 Knurled Blue.
Q-2-03 Knurled Stainless Steel,
Ruger New Model Single Six .22, .32, .22 convertible, Bisleys, Single-Ten, Single Seven, etc. 2.520".
Q-3-01 Knurled Blue.
Q-3-02 Knurled Stainless.
Q-3-04 Special order Long Shank .250" Diameter Reamer.
Q-3-05 Special order Long Shank .251" Diameter Reamer.
Note: Ruger (3 screw) Old Models use the same base pins for all correspnding frames sizes. You can use the New Blackhawk (longest) and shotren to length. The spring loaded plunger is not needed. The las nmber is the mazimum lenth measured from under the head to end the bas pin, not the plunger.
Video of Installation of the Power Custom Ruger Base Pins
This product was added to our catalog on Monday 11 August, 2003.