PC Base Pin for Ruger® Base Pin - Keith #5

All Power Custom Base pins for the Ruger® Single Actions are hardened, centerless ground to .2495" Diameter, and handsomely finished. Locking pins have an Allen set screw in the head to hold the pin in place against recoil. Installation instructions are included, and on most guns these pins drop right in. This is the Keith #5 Base pin.

Please post in the comments section the gun you own to help determine the correct base pin you need. You can also measure from the front of the frame to the front of the frame, that is the approx. length of the base pin.

Ruger® New Blackhawk®, Vaquero, Super Blackhawk®, Bisley™ (large frames) 2.875".

Q-1-01 Keith #5 Blue.

Q-1-02 Keith #5 Stainless Steel.

Ruger® New Vaquero, Bisley™, XR3, (small frame) 2.750".

Q-1-05 Keith #5 Blue. Q-2-01 Keith #5 Stainless Steel,

Please note the Single Sixes are Discontinued:

Ruger® New Model Single Six .22, .32, .22 convertible, Bisleys™, Single-Ten®, Single Seven™, etc. 2.520".

The Single Sixes are Discontinued.

Q-2-04 Keith #5 Blue.

Q-2-05 Keith #5 Stainless.

Note: Ruger® (3 screw) Old Models use the same base pins for all correspnding frames sizes. You can use the New Blackhawk® (longest) and shorten to length. The spring loaded plunger is not needed. The lasy number is the maximum length measured from under the head to end the base pin, not the plunger.

Video of Installation of the Power Custom Ruger Base Pins..