PC Competition Plus Red Trigger Kit for Ruger 10/22 Fits BX's

Quality parts replace the parts in the factory trigger housings, that allows adjustment for pre-travel, overtravel, and trigger pull weight. (in both the older aluminum model and the newer composite trigger housings including the BX).
The parts are drop in with the possibly of fitting the toe of the sear to be sure the safety will slide under the sear when the hammer is in the cocked position. REMEMBER the SAFETY has to work properly.

After installation and all function of parts are correct, you can now adjust the trigger overtravel screw with the 1/16" allen wrench. Screw is set in medium thread locker to prevent the screw from turning freely. If the overtravel screw is too tight to rotate with the allen wrench, apply heat to the thread locker until the screw can be rotated. If you set the overtravel to the minimum, the trigger may still function. But, if you pull the trigger hard, it may stick and not return forward. If this happens, give it a little more overtravel. (If you measure, it should be between .004" and .008").

NOTICE: Do not stone or polish the engagement surfaces of the sear or hammer. Warranty is void if you attempt to alter these areas. Reducing the weight of the trigger pull is accomplished by cutting the length of the trigger return spring.


Disclaimer: The user is responsible for the proper installation and use of these items. For most users, we recommend a 2 lb. plus trigger pull. This is usually accomplished by using the factory trigger return spring or one of the standard trigger return spring in the kit. Only responsible, experienced, competitors should use light trigger pulls.