AK47 Fixed Stock 7.62 Flat - Top Rail Bent and Trimmed


Why buy flats from mus and not buy the cheap pre-bent top rail ones from everybody else? That's simple... We actually know what it takes to bend one and how everything works. With that in mind I made these flats with the holes in the correct locations and the correct shape in the front of the receiver. No egging out of holes to get mags to latch in. Just puton the trigger guard and set the front trunnion even with the front of thereceiver and you're done. No more distorted trigger pin holes since a hole too close to a bend will always distort. The hole is smaller then it is reamed to size after bending. The rails have mag stabilizers on both sides as well as a bump on the right hand rail to move the hammer closer to the middle of the receiver. You won't see that on the cheap rails, I guarantee that!.

To use these flats you will need to have a 5mm and 7mm reamer. This will help solve two of the problems with the flats currently on the market. In all there are at least five problems that will be fixed with these flats compared to any offered before.

The rails that will come with the flats are pictured below. They have mag stabilizers on both rails to keep the mag from tilting and causing feed problems. The picture of the rails are from the actual samples and are made from 4130 steel. Yes, I had samples made and tested them before shipping any flats. I bet no other company that sells flats ever went to that much trouble. These were designed from an actual receiver from Romania.

Add to Cart:

  • Model: B1-71
  • Manufactured by: AK Builder

This product was added to our catalog on Monday 22 February, 2010.

Copyright © 2022 Grand Masters L.L.C..