Redhawk®, Blackhawk Hunter® & Bisley® Hunter Scope Mount Black or Silver

Scope Mount REDHAWK®, Blackhawk® Hunter® and Bisley®Hunter. This scope mount fits the NEW and Older Style Redhawks and Blackhawks with the integral scope ring cuts in the barrel. This is a no drill and tap scope mount for installation on the cuts made by the Ruger factory. Installs in minutes so you can add the scope or dot sight of your choice using Weaver style attaching points. Choose from Black or Silver.

Caution: Not for use with .44 Magnum ammunition loaded beyond .250gr bullets with velocity exceeding SAAMI specs (SAAMI specs are .250gr bullet at 1150 FPS). Exceeding this power factor requires using the drill and tap version of our mount. Click Here for the Drill and Tap Scope Mount

This scope mount fits ALL HUNTER®MODELS including the Single Six Hunter

This scope mount fits the NEW and Older Style Redhawks® and Blackhawks® Single Six® with the integral scope ring cuts in the barrel. This is a no drill and tap scope mount for installation on the cuts made by the Ruger® factory. Installs in minutes so you can add the scope or dot sight of your choice.

Accepts all Weaver style rings and accessories and Picatinny rings and accessories. Screws and washers supplied.

Installation Video

NOTE ABOUT VIDEO: The scope mount shown in this video is not the Hunter Mount it is the Super Redhawk® Mount. The installation is similar but the scope mounts and locations are different. The Hunter mount is flat on the bottom and mounts out on the barrel.

Installation Instructions

Part Numbers:

• RRHNGS
• RRHNGB