PC Knurled Locking Base Pin for Ruger® Single Action

All Power Custom Base Pins for the The Ruger® Single Action are hardened, centerless ground to .2495" Diameter, and handsomely finished. Locking pins have an Allen set screw in the head to hold the pin in place against recoil. Installation instructions are included, and on most guns these pins drop right in.

Ruger® New Blackhawk®, Vaquero, Super Blackhawk®, Bisley™ (large frames) 2.875".

Q-1-03 Knurled Blue.

Q-1-04 Knurled Stainless Steel.

Ruger® New Vaquero, Bisley™, XR3, (small frame) 2.750".

Q-2-02 Knurled Blue. Q-2-03 Knurled Stainless Steel,

The Single Sixes are Discontiued.
Ruger® New Model Single Six® .22, .32, .22 convertible, Bisleys™, Single-Ten®, Single Seven™, etc. 2.520".

The Single Sixes are Discontinued

Q-3-01 Knurled Blue.

Q-3-02 Knurled Stainless.

Q-3-04 Special order Long Shank .250" Diameter Reamer.

Q-3-05 Special order Long Shank .251" Diameter Reamer.

Note: Ruger® (3 screw) Old Models use the same base pins for all correspnding frames sizes. You can use the New Blackhawk® (longest) and shorten to length. The spring loaded plunger is not needed. The last number is the maximum length measured from under the head to end the base pin, not the plunger.

Video of Installation of the Power Custom Ruger Base Pins..